Nxtrend - With Nxtrend you can control your Xtrend STB using most features which you normally can do through the decoder's Web Interface or your Remote Control. You can set and handle timers, read EPG, consult your movies/recordings, send messages and much more. Many features are also available remotely if you set up port-forwarding on your router. You can also use Nxtrend and its virtual Remote Control in replacement of your original Remote Control (most commands are supported). In addition, you can watch TV and movies by streaming in your LAN. All this directly from your Android.
· To use Nxtrend, an Xtrend/ClarkTech STB is required. However, Nxtrend supports multiple-profiles and once you have set up an original Xtrend/Clarke-Tech decoder in your decoder-profiles, you may add other Linux-based decoders (compatible with E1 and E2).
· For streaming TV and movies in your LAN, a rather powerful Android-device is required but most higher end devices sold over last two years should be sufficient. In addition, you need to install an external Android video-player.
What's New in This Release:
· Reviewed first-time configuration. Should fix sporadic cases when detection of et/ct-receiver was not successful
· Fixed streaming of movies/recordings when authentication of OpenWebIf is enabled.